 | Instead of a regular ring, your special BatPhone can have a distinctive low-frequency raspy buzz, kind of like a Bronx Cheer (also known as an "unvoiced linguolabial trill," raspberry, razz or fart sound), that's sure to attract attention when an important call comes in. This price is in addition to the price of the phone, not for a buzzer purchased alone. The bell will be removed when the buzzer is installed. $15.00 |
|
 | Your special BatPhone doesn't have to sound like an ordinary phone. Instead of a regular ring or a basic buzz, it can be equipped with an exciting attention-getting bat-like electronic ring signal. It's powerful enough to wake up Alfred. This price is in addition to the price of the phone, not for an electronic signal purchased alone. The bell will be removed when the electronic signal is installed. The signal is pre-set to a "medium" volume level, but it can be easily adjusted. (Similar to photo.) $24.00 |
|
 | The phone above has no dial or touchtone buttons, and most people use it only for receiving calls.
However, it can make outgoing calls if you connect it to an office phone system that has "memory" or to our compact and convenient BatDialer. After a few seconds of programming with an ordinary touchtone phone, its all set to call any number you want, with up to 32 digits. You can even program in pauses if necessary, and it will work with business phone systems, or when directly connected to the phone company.
It doesn't require any power. Installation is super simple. It has two jacks -- one for the no-dial phone, and one for a cord to go to the phone jack. As soon as you pick up the phone's handset, it starts dialing your call.
Length: 6.5 in.
Width: 2.75 in.
Height: 1.75 in.
Photo is not exact. It does NOT say BatPhone on it.
Shipping is free anywhere in the USA. $122.00 |
|
 | If you order a BatPhone and a BatDialer from us, we can install and test the dialer for you before shipping. We can also pre-program a number into the BatDialer at no additional charge. If you want programming, tell us the number in the comments section of the order form.
$25.00 |
|
 | Our crystal clear dome protects and shows off your BatPhone or other treasures.
The silvery handle matches the chrome ring around the flashing light in the center of the phone. If you prefer, you can remove it, and install a handle more like the one in Commissioner Gordon's office.
NOTE: The dome does not have a notch for phone cord clearance because some people may prefer to mount the phone and dome on a base and bring up the cord from the bottom. If you want to make a notch you can use a file, or melt a small notch into the plastic with a soldering iron.
The price includes "ground" shipping
to all 50 states, even to Alaska and Hawaii. Faster shipping is available for an additional charge.
If you're buying the dome with a BatPhone, the online order will show the full price for the dome. We'll make the price adjustment when we process your order and your credit card charge will show the lower price. $35.00 |
|
 | Great for use with no-dial/no-memory phones. When either phone goes off-hook, the other phone rings. Provides 2 seconds of dial tone and ring-back signal to the calling phone. Uses simple RJ11 modular jacks. You can have up to 2.6 miles of 24 gage wire between phones. Even works with cordless phones. (Phones are not included.) $135.00 |
|
 | Under Federal law, your local phone company is only required to provide enough power to ring the bells in four standard phones.
We've heard a few reports from people who've bought our BatPhones that the power from their phone companies was too weak to flash the lights. Some people have
had similar problems when they connected BatPhones to office PABX phone systems, or cable TV phone service or VoIP phone service.
Some times these folks were able to get the
problems resolved by complaining, but in other cases they were not; and that's why we are showing this power booster on this page. It's normally used by people
who need to connect more than four phones on a phone line, but it should also solve the BatPhone light problem.
It's a handy device that is capable of ringing twelve standard ("1 REN") telephones or phone-like devices and does not affect the normal
operation of the telephone line or features provided by the phone company, such
as Caller ID and Call Waiting.
It increases the ringing power of an analog telephone line, VoIP line, analog PABX extension, analog ISDN Terminal Adapter port, or any other telecom device which provides ringing.
It duplicates the incoming ring frequency and cadence allowing it to be compatible with custom ringing features. $209.00 |
|
